You are here

RFID implementation

4 posts / 0 new
Last post
RFID implementation

I have a question regarding RFID impl. and testing process. Is there any standard  procedure ?
What is the other equipment needed for the implementation?
Is it required to map the em field strength on the reading area? or just its the bext way to go by trial and error positions.

Edited by: admin on 05/16/2010 - 04:31
Re: RFID implementation

Generally it is called sitesurvey which involves roughly the following steps...

- Product Tagging Test
- Scanning the area with a spectrum analyzer
- Determine a place to install your readers. Avoid metal and water
- Trial and error:  keeping testing and adjust the attennae and readers until you get the result that you want

Re: RFID implementation

Thanks LeiVue.

Dalia Hassanin
Re: RFID implementation

Radio Frequency Identification
Call for Papers
The International Journal of Antenna and Propagation (IJAP) is publishing a special issue on radio frequency identification (RFID) technologies. RFID systems are used for electronically identifying, locating, and tracking products, animals, vehicles. Passive tags (transponders) do not have a battery and have limited range, typically about one meter. Active tag systems have a power source and much longer range. Current RFID research and development include theory, antenna design, wireless communication, networking, system-on-chip IC development, database management, propagation theory, signal processing, embedded system design, and more.

This special issue is to present new RFID-related techniques to address theoretical and technical implementation challenges

Papers that reflect the current and future methods are solicited.

Topics of interest include (but are not limited to):

Reader and tag antennas
Metallic object tag antenna design
RF- and antenna-related techniques to improve the recognition rate of RFID
Miniaturization of tag antenna
Reading range for different antennas
RFID measurements and modeling
Printable tag design and analysis
Active and passive tag antennas
Location technologies
RFID near-field and far-field analyses
RFID impedance matching and related topics
Smart label tag antennas
RFID and USN system (ubiquitous sensor network)
Authors should follow International Journal of Antennas and Propagation manuscript format described at the journal site Prospective authors should submit an electronic copy of their complete manuscript through International Journal of Antennas and Propagation Manuscript Tracking System at, according to the following timetable:

Manuscript Due March 1, 2007
Acceptance Notification July 1, 2007
Final Manuscript Due October 1, 2007
Publication Date 1st Quarter, 2008

Guest Editors:
Youchung Chung, Department of Information and Communication Engineering, Daegu University, Gyeongsan, Gyeongbuk 712-714, South Korea; mailto:[email protected]

Manos Tentzeris, School of Electrical and Computer Engineering, Georgia Institute of Technology, Atlanta, GA 30332-0250, USA; mailto:[email protected]

Pavel Nikitin, Intermec Technologies Corporation, 6001 36th Avenue West, Everett, WA 98203-1264, USA; mailto:[email protected]

Junho Yeo, System Research Team, Electronics and Telecommunications Research Institute, 161 Gajeong-Dong, Yuseong-Gu, Daejeon 305-700, South Korea; mailto:[email protected]

Jin Mitsugi, Auto-ID Labs, Keio Research Institute at Shonan-Fujisawa Research Support Center (SFC), Keio University, 5322 Endo, Fujisawa 252-8520, Japan; mailto:[email protected]

Markku Kivikoski, Institute of Electronics, Tampere University of Technology, 33101 Tampere, Finland; mailto:[email protected]

Hans-Erik Nilsson, Depatment of Information Technology and Media, Mid Sweden University, 851 70 Sundsvall, Sweden; mailto:[email protected]

Zhi Ning Chen, Radio Systems Department, Communications Division, Institute for Infocomm Research, Singapore 119613; mailto:[email protected]